Home › Engine / Hybrid System › M20A-FXS (FUEL) › FUEL PRESSURE SENSOR › 2019.09–2020.08
RM32K0E _51 Engine / Hybrid System _083996 M20A-FXS FUEL _0404496 FUEL PRESSURE SENSOR A

M20A-FXS FUEL  FUEL PRESSURE SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during No. 2 fuel pressure sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*1: When performing learning using the GTS.

Click here(Click here)

Disconnect cable from negative auxiliary battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Simple intelligent parking assist system*1
Parking Support Brake System*1
Toyota parking assist-sensor system*1
Pre-collision System
Initialize back door lock Power door lock control system (Click here)
·

Replacement of No. 2 fuel pressure sensor

·

Cleaning the deposits from the throttle body with motor assembly

·

Gas leaks from exhaust system is repaired


Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

CAUTION:
·
A360563

Never perform work on fuel system components near any possible ignition sources.

·

Vaporized fuel could ignite, resulting in a serious accident.

·
A360564

Do not perform work on fuel system components without first disconnecting the cable from the negative (-) auxiliary battery terminal.

·

Sparks could cause vaporized fuel to ignite, resulting in a serious accident.



NOTICE:

This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2. DISCHARGE FUEL SYSTEM PRESSURE

Hide 25620 3.REMOVE EGR VALVE ASSEMBLY

Hide 89458H 4.REMOVE NO. 2 FUEL PRESSURE SENSOR

a.
A434094

Disconnect the No. 2 fuel pressure sensor connector.


b.
A434095

Using an 8 mm socket wrench, remove the bolt and No. 2 fuel pressure sensor holder from the fuel delivery pipe sub-assembly.


c.
A434096

Remove the No. 2 fuel pressure from the fuel delivery pipe sub-assembly.


d.
A427249

Remove the O-ring from the No. 2 fuel pressure sensor.