Home › Engine / Hybrid System › M20A-FXS (EMISSION CONTROL) › EGR VALVE › 2019.09–2020.08
RM32K0E _51 Engine / Hybrid System _083997 M20A-FXS EMISSION CONTROL _0404516 EGR VALVE A

M20A-FXS EMISSION CONTROL  EGR VALVE  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during EGR valve assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*1: When performing learning using the GTS.

Click here(Click here)

Disconnect cable from negative auxiliary battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Simple intelligent parking assist system*1
Parking Support Brake System*1
Toyota parking assist-sensor system*1
Pre-collision System
Initialize back door lock Power door lock control system (Click here)
·

Replacement of EGR valve assembly

·

Gas leaks from exhaust system is repaired


Inspection After Repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

NOTICE:

This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

Hide 25680 1.REMOVE EGR COOLER ASSEMBLY

Hide 25601 2.REMOVE NO. 1 EGR PIPE SUB-ASSEMBLY

a.
A433451

Disconnect the EGR valve assembly connector.


b.
A427802

Using an 8 mm socket wrench, remove the 4 bolts and No. 1 EGR pipe sub-assembly from the intake manifold and EGR valve assembly.


c.
A427803

Remove the EGR valve adapter gasket from the No. 1 EGR pipe sub-assembly.


d.
A427804

Remove the EGR inlet gasket from the intake manifold.


Hide 25620 3.REMOVE EGR VALVE ASSEMBLY

a.
A433449C01
1.5,0.146 1.646,0.146 1.646,0.146 1.76,0.302 true 1.26,1.448 1.563,1.448 true 1.323,0.063 1.552,0.25 0.229,0.188 10 true *1 1.083,1.365 1.292,1.552 0.208,0.188 10 true *2
*1 No. 4 Water By-pass Hose
*2 No. 8 Water By-pass Hose


Slide the clip and remove the No. 4 water by-pass hose from the EGR valve assembly.


b.

Slide the clip and disconnect the No. 8 water by-pass hose from the EGR valve assembly.


c.
A427806

Using the 8 mm socket wrench, remove the 2 bolts and EGR valve assembly.