Home › Engine / Hybrid System › M20A-FXS (EMISSION CONTROL) › EGR COOLER › 2019.09–2020.08
RM32K0E _51 Engine / Hybrid System _083997 M20A-FXS EMISSION CONTROL _0404517 EGR COOLER A

M20A-FXS EMISSION CONTROL  EGR COOLER  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during EGR cooler assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*1: When performing learning using the GTS.

Click here(Click here)

Disconnect cable from negative auxiliary battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Simple intelligent parking assist system*1
Parking Support Brake System*1
Toyota parking assist-sensor system*1
Pre-collision System
Initialize back door lock Power door lock control system (Click here)
Gas leaks from exhaust system is repaired Inspection After Repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

NOTICE:

This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

Hide 1.DRAIN ENGINE COOLANT (for Engine)

Hide G9200 2.REMOVE INVERTER WITH CONVERTER ASSEMBLY

Hide 25680 3.REMOVE EGR COOLER ASSEMBLY

a.
A435435C01
2.365,0.875 2.781,0.458 true 1.063,0.177 1.281,0.458 true 0.781,0.021 1.031,0.198 0.25,0.177 10 true *1 2.729,0.313 2.979,0.49 0.25,0.177 10 true *2
*1 No. 4 Water By-pass Hose
*2 No. 3 Water By-pass Hose


Slide the 2 clips and disconnect the No. 4 water by-pass hose and No. 3 water by-pass hose from the EGR cooler assembly.


b.
A427809

Remove the 2 bolts and 3 nuts and EGR cooler assembly from the cylinder head sub-assembly and EGR valve assembly.


c.
A427810

Remove the EGR valve gasket from the EGR valve assembly.


d.
A402223

Remove the EGR cooler gasket from the EGR cooler assembly.