Home › Drivetrain › P711 (HYBRID TRANSMISSION / TRANSAXLE) › TRANSMISSION CONTROL CABLE › from 2019.09
RM32K0E _52 Drivetrain _084042 P711 HYBRID TRANSMISSION / TRANSAXLE _0404753 TRANSMISSION CONTROL CABLE A

P711 HYBRID TRANSMISSION / TRANSAXLE  TRANSMISSION CONTROL CABLE  INSTALLATION  


PROCEDURE

Hide 23841G 1.INSTALL FUEL HOSE CLAMP

HINT:

Perform this procedure only when replacement of the fuel hose clamp is necessary.


a.

Engage the 2 claws to install the fuel hose clamp to the transmission control cable assembly.


Hide 33820B 2.INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY

a.

Pass the transmission control cable assembly into the vehicle and install the transmission control cable assembly to the vehicle body with the 2 nuts.

Torque:
6.0 N*m (61 kgf*cm, 53 in.*lbf)


b.

Engage the guide to connect the transmission control cable assembly to the vehicle body.


c.

Install the nut.

Torque:
6.0 N*m (61 kgf*cm, 53 in.*lbf)


d.

Install the transmission control cable assembly to the hybrid inverter protector assembly with the bolt.

Torque:
12 N*m (122 kgf*cm, 9 ft.*lbf)


e.

Engage the clamp to connect the transmission control cable assembly.


f.

Engage the clamp to connect the fuel tube sub-assembly.


g.

Connect the transmission control cable assembly to the No. 1 transmission control cable bracket with a new clip.


h.
C377951N01
2.833,1.385 2.99,1.583 0.156,0.198 10 false N 2.583,2 2.75,2.177 0.167,0.177 10 false P

Turn the control shaft lever clockwise until it stops, and then from that position turn it counterclockwise by 2 notches to set it to the N position.


i.

Connect the transmission control cable assembly to the control shaft lever with the nut.

Torque:
12 N*m (122 kgf*cm, 9 ft.*lbf)


j.
C366437C01
0,0 0,0 false
V113147

Install in this Direction


Connect the transmission control cable assembly to the floor shift shift lever assembly.

NOTICE:

Make sure that the transmission control cable assembly is securely locked.



k.
C366436C01
0,0 0,0 false
V113147

Install in this Direction


Connect the end of the transmission control cable assembly to the floor shift shift lever assembly.

NOTICE:
·

Before connecting the transmission control cable assembly, check that the park/neutral position switch and shift lever are in neutral.

·

Install the end of the transmission control cable assembly so that the lock piece faces the driver side.

·

Install the end of the transmission control cable assembly all the way to the base of the pin.




Hide 3.INSTALL REAR CONSOLE BOX ASSEMBLY

Hide 33504F 4.INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY

Hide 58151 5.INSTALL FRONT NO. 1 FLOOR HEAT INSULATOR

a.

Install the front No. 1 floor heat insulator to the vehicle body with the 3 nuts.

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


Hide 17410 6.INSTALL FRONT EXHAUST PIPE ASSEMBLY

Hide 51410 7.INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY