Home › Drivetrain › P711 (HYBRID TRANSMISSION / TRANSAXLE) › SHIFT LEVER POSITION SENSOR › from 2019.09
RM32K0E _52 Drivetrain _084042 P711 HYBRID TRANSMISSION / TRANSAXLE _0404799 SHIFT LEVER POSITION SENSOR A

P711 HYBRID TRANSMISSION / TRANSAXLE  SHIFT LEVER POSITION SENSOR  REMOVAL  


PROCEDURE

Hide 1.SECURE VEHICLE

a.

Fully apply the parking brake and chock a wheel.

CAUTION:
C332327

·

Make sure to apply the parking brake and chock a wheel before performing this procedure.

·

If the vehicle is not secure and the shift lever is moved to N, the vehicle may suddenly move, possibly resulting in an accident or serious injury.




Hide 51410 2.REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY

Hide 33820B 3.DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

a.

Move the shift lever to N.


b.
C403280

Remove the nut and disconnect the transmission control cable assembly from the control shaft lever.


c.

Remove the clip and disconnect the transmission control cable assembly from the No. 1 transmission control cable bracket.


Hide 89451A 4.REMOVE SHIFT LEVER POSITION SENSOR

a.
C403281

Disconnect the shift lever position sensor connector.


b.
C403282

Remove the nut, washer and control shaft lever from the shift lever position sensor.


c.
C403283C02
1.813,1.156 2.146,1.49 true 1.156,0.865 1.49,1.198 true 2.167,1.521 2.406,1.708 0.24,0.188 10 true *1 0.896,0.74 1.125,0.917 0.229,0.177 10 true *a
*1 Lock Plate
*a Protective Tape


Using a screwdriver with its tip wrapped with protective tape, pry out the tabs of the lock plate.


d.
C403284C05
1.052,1.094 1.469,1.094 true 1.75,1.042 2.01,0.677 true 2.073,0.563 2.302,0.792 0.229,0.229 10 true *1 0.813,1 1,1.177 0.188,0.177 10 true *2
*1 Lock Nut
*2 Lock Plate


Remove the lock nut and lock plate from the shift lever position sensor.


e.
C403285

Remove the 2 bolts and shift lever position sensor from the hybrid vehicle transaxle assembly.