Home › Drivetrain › P711 (HYBRID TRANSMISSION / TRANSAXLE) › SHIFT LEVER POSITION SENSOR › from 2019.09
RM32K0E _52 Drivetrain _084042 P711 HYBRID TRANSMISSION / TRANSAXLE _0404799 SHIFT LEVER POSITION SENSOR A

P711 HYBRID TRANSMISSION / TRANSAXLE  SHIFT LEVER POSITION SENSOR  INSTALLATION  


PROCEDURE

Hide 89451A 1.INSTALL SHIFT LEVER POSITION SENSOR

a.

Move the shift lever to N.


b.
C403286

Clean and degrease the 2 bolt holes of the hybrid vehicle transaxle assembly.


c.

Temporarily install the shift lever position sensor to the hybrid vehicle transaxle assembly with 2 new bolts.

NOTICE:
·

Do not reuse the shift lever position sensor if it has been dropped or subjected to a severe impact.

·

Do not allow moisture to adhere to the connector terminal.




d.

Install the lock plate to the shift lever position sensor with the lock nut.

Torque:
6.9 N*m (70 kgf*cm, 61 in.*lbf)


e.

Temporarily install the control shaft lever to the shift lever position sensor.


f.
C377951N01
2.833,1.385 2.99,1.583 0.156,0.198 10 false N 2.583,2 2.75,2.177 0.167,0.177 10 false P

Turn the control shaft lever clockwise until it stops, then turn it counterclockwise 2 notches.


g.

Remove the control shaft lever from the shift lever position sensor.


h.
C377952C01
2.26,1.042 2.99,1.042 true 2.24,0.792 2.979,0.792 true 3.031,0.677 3.302,0.906 0.271,0.229 10 false *a 3.031,0.938 3.26,1.156 0.229,0.219 10 false *b 0.677,0.615 0.979,0.823 0.302,0.208 10 false *c
*a Neutral Basic Line
*b Indicator
*c Range of Play


Align the indicator with the neutral basic line.

NOTICE:

The indicator of the lock plate has a certain amount of play. Align the center point of the range of play with the neutral basic line.



i.

Tighten the 2 bolts.

Torque:
11 N*m (112 kgf*cm, 8 ft.*lbf)


j.

Using a screwdriver with its tip wrapped with protective tape, secure the lock nut with the lock plate.


k.

Install the control shaft lever and washer to the shift lever position sensor with the nut.

Torque:
12.7 N*m (130 kgf*cm, 9 ft.*lbf)


l.

Connect the shift lever position sensor connector.


Hide 33820B 2.CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

a.

Connect the transmission control cable assembly to the No. 1 transmission control cable bracket with a new clip.


b.

Connect the transmission control cable assembly to the control shaft lever with the nut.

Torque:
12 N*m (122 kgf*cm, 9 ft.*lbf)


Hide 3.INSPECT SHIFT LEVER POSITION SENSOR POSITION

Hide 51410 7.INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY