Home › General › MAINTENANCE › 2ZR-FXE AUXILIARY BATTERY › 2019.09–2020.08
RM32K0E _V1 General _059911 MAINTENANCE _0295427 2ZR-FXE AUXILIARY BATTERY A

MAINTENANCE  2ZR-FXE AUXILIARY BATTERY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the auxiliary battery removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link

*1: When performing learning using the GTS.

Click here(Click here)

Disconnect cable from negative auxiliary battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Toyota parking assist-sensor system*1
Parking support brake system*1
Simple intelligent parking assist system*1
Pre-collision system
Memorize steering angle neutral point Panoramic view monitor system (Click here)
Initialize back door lock Power door lock control system (Click here)

PROCEDURE

Hide 1. PRECAUTION

NOTICE:
·

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When replacing the auxiliary battery, use a new auxiliary battery of the same dimensions with a capacity of 51 Ah or more at a 20-hour rate.



Hide 2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

a.
A387986

Loosen the nut and disconnect the cable from the negative (-) auxiliary battery terminal.

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION



Hide 3.REMOVE AUXILIARY BATTERY

a.

Disengage the 2 claws and open the battery terminal cap in the order shown in the illustration.

A387473C02
0.917,0.146 1.229,0.344 0.313,0.198 10 false *a 0.823,2.156 0.979,2.354 0.156,0.198 10 true 1 2.042,1.281 2.198,1.479 0.156,0.198 10 true 1 5.625,1.865 5.781,2.063 0.156,0.198 10 true 2
*a Top View of Claws - -
V113146

Push Battery Terminal Cap Here
V113147

Push
V113148

Open - -



b.
A387349

Loosen the nut and disconnect the cable from the positive (+) auxiliary battery terminal.


c.
A394390

Remove the battery insulator from the auxiliary battery.


d.
A387988

Remove the bolt and battery clamp No. 2.


e.
A394391

Remove the auxiliary battery from the vehicle.