Home › General › MAINTENANCE › M20A-FXS AUXILIARY BATTERY › 2019.09–2020.08
RM32K0E _V1 General _059911 MAINTENANCE _0404803 M20A-FXS AUXILIARY BATTERY A

MAINTENANCE  M20A-FXS AUXILIARY BATTERY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the auxiliary battery removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link

*: When performing learning using the GTS.

Click here(Click here)

Disconnect cable from negative auxiliary battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Simple intelligent parking assist system*1
Parking Support Brake System*1
Toyota parking assist-sensor system*1
Pre-collision System
Initialize back door lock Power door lock control system (Click here)

PROCEDURE

Hide 1. PRECAUTION

NOTICE:
·

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When replacing the auxiliary battery, use a new auxiliary battery of the same dimensions with a capacity of 51 Ah or more at a 20-hour rate.



Hide 58410B 2.REMOVE DECK BOARD ASSEMBLY

Hide 58440 3.REMOVE BATTERY SERVICE HOLE COVER ASSEMBLY (w/o Spare Tire)

a.
A451650C01
0,0 0,0 false
V113147

Remove in this Direction


Remove the battery service hole cover assembly as shown in the illustration.


Hide 4.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

a.
A451417

Loosen the nut and disconnect the cable from the negative (-) auxiliary battery terminal.

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION



Hide 5.REMOVE AUXILIARY BATTERY

a.
A429314C01
0,0 0,0 false
V113147

Open


Disengage the claw and open the battery terminal cap shown in the illustration.


b.
A429316

Loosen the nut and disconnect the cable from the positive (+) auxiliary battery terminal.


c.
A454082

Disconnect the auxiliary battery hose.


d.
A454083

Remove the bolt, nut and battery clamp sub-assembly.


e.
A451418

Remove the auxiliary battery from the vehicle shown in the illustration.