Home › Engine / Hybrid System › M20A-FXS (ENGINE CONTROL) › THROTTLE BODY › from 2019.09
RM32K0E _51 Engine / Hybrid System _083960 M20A-FXS ENGINE CONTROL _0404835 THROTTLE BODY A

M20A-FXS ENGINE CONTROL  THROTTLE BODY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during throttle body with motor assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
·

Replacement of throttle body with motor assembly

·

Cleaning the deposits from the throttle body with motor assembly


Inspection After Repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

NOTICE:

This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

Hide 51444A 1.REMOVE REAR ENGINE UNDER COVER LH

Hide 2.DRAIN ENGINE COOLANT (for Engine)

Hide 3.REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE

a.
A439244C01
1.938,0.906 2.146,1.094 0.208,0.188 10 true *a 2.49,0.469 2.708,0.625 0.219,0.156 10 true *b 2.438,1.792 2.656,1.979 0.219,0.188 10 true *c 1.802,1.792 2.021,1.979 0.219,0.188 10 true *c 1.74,0.458 1.958,0.615 0.219,0.156 10 true *b
*a Wire Harness Clamp
*b Clamp
*c Guide


Disconnect the mass air flow meter connector and disengage the wire harness clamp.


b.

Disengage the 2 clamps and 2 guides.


c.
A439245C01
0.969,0.313 1.396,0.313 true 1.417,0.229 1.656,0.448 0.24,0.219 10 true *1
*1 No. 2 Ventilation Hose


Slide the clip to disconnect the No. 2 ventilation hose from the cylinder head cover sub-assembly.


d.

Loosen the hose clamp to remove the air cleaner cap with air cleaner hose from the throttle body with motor assembly.


Hide 22030 4.REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY

a.
A439246

Disconnect the throttle body with motor assembly connector.


b.

Slide the clip and disconnect the No. 8 water by-pass hose from the throttle body with motor assembly.


c.

Using an 8 mm socket wrench, remove the 3 bolts to separate the throttle body with motor assembly from the intake manifold.


d.
A439247

Slide the clip and disconnect the No. 5 water by-pass hose to remove the throttle body with motor assembly.

NOTICE:

If the throttle body with motor assembly has been struck or dropped, replace it.



Hide 22271 5.REMOVE THROTTLE BODY GASKET

a.
A439248

Remove the throttle body gasket from the intake manifold.