Home › Engine / Hybrid System › M20A-FXS (ENGINE CONTROL) › ECM › 2019.09–2020.08
RM32K0E _51 Engine / Hybrid System _083960 M20A-FXS ENGINE CONTROL _0404836 ECM A

M20A-FXS ENGINE CONTROL  ECM  INSTALLATION  


PROCEDURE

Hide 89667E 1.INSTALL NO. 1 ECM BRACKET

a.

Install the No. 1 ECM bracket to the ECM with the 2 screws.

Torque:
4.5 N*m (46 kgf*cm, 40 in.*lbf)


Hide 89668 2.INSTALL NO. 2 ECM BRACKET

a.

Install the No. 2 ECM bracket to the ECM with the 2 screws.

Torque:
4.5 N*m (46 kgf*cm, 40 in.*lbf)


Hide 89661 3.INSTALL ECM

a.

Install the ECM with the bolt and nut.

Torque:
Bolt : 12.5 N*m (127 kgf*cm, 9 ft.*lbf)
Nut : 8.0 N*m (82 kgf*cm, 71 in.*lbf)

NOTICE:

If the ECM has been struck or dropped, replace it.



b.

Engage the 2 clamps.


c.

Install the engine wire to the No. 1 ECM bracket with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


d.
A439254

Connect the 2 ECM connectors and lower the 2 lock levers.

NOTICE:
·

When connecting the ECM connectors, make sure that dirt, water or other foreign matter does not contact the connecting parts of the ECM connectors.

·

Be sure to securely connect the ECM connectors.




Hide 4.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

Click hereGeneral>MAINTENANCE>M20A-FXS AUXILIARY BATTERY>INSTALLATION

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION