Home › Engine / Hybrid System › M20A-FXS (ENGINE CONTROL) › KNOCK SENSOR › from 2019.09
RM32K0E _51 Engine / Hybrid System _083960 M20A-FXS ENGINE CONTROL _0404842 KNOCK SENSOR A

M20A-FXS ENGINE CONTROL  KNOCK SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:

This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

Hide 89615 1.INSTALL KNOCK SENSOR

HINT:

Perform "Inspection After Repair" after replacing the knock sensor.

Click hereEngine / Hybrid System>M20A-FXS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION


a.
A406048C02
1.698,2.094 2.01,2.25 0.313,0.156 10 false *a 0.677,3.979 0.99,4.135 0.313,0.156 10 false *b 1.26,2.573 1.573,2.729 0.313,0.156 10 false *c 1.958,2.542 2.271,2.698 0.313,0.156 10 false *d
*a Top of Vehicle
*b Right Side of Vehicle
*c 15°
*d 5°


Install the knock sensor to the cylinder block sub-assembly with the bolt so that the knock sensor installation position is as shown in the illustration.

Torque:
20 N*m (204 kgf*cm, 15 ft.*lbf)

NOTICE:
·

If the knock sensor has been struck or dropped, replace it.

·

Make sure that the knock sensor is in the correct position.




b.

Connect the knock sensor connector.


Hide 3.PERFORM INITIALIZATION

a.

Perform "Inspection After Repair" after replacing the knock sensor.

Click hereEngine / Hybrid System>M20A-FXS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION