This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
1.INSTALL VACUUM HOSE
Install the vacuum hose to the intake manifold.
17177
2.INSTALL NO. 1 INTAKE MANIFOLD TO HEAD GASKET
Install a new No. 1 intake manifold to head gasket to the intake manifold.
17111
3.INSTALL INTAKE MANIFOLD
Set the intake manifold.
At this time, do not install the parts with bolts or nuts.
Temporarily install the intake manifold and No. 2 fuel delivery guard to the cylinder head sub-assembly with the 4 bolts and 2 nuts.
Tighten the 3 bolts and 2 nuts in the order shown in the illustration.
Tighten the bolt.
17138B
4.INSTALL INTAKE MANIFOLD STAY
Engage the guide to install the intake manifold stay.
Install the bolt (B).
Using an 8 mm socket wrench, install the bolt (A).
Engage the clamp to connect the HV air conditioning wire to the No. 1 water hose clamp bracket.
5.INSTALL BRACKET
| *1 | Wire Harness Clamp Bracket |
| *2 | No. 2 Water Hose Clamp Bracket |
Install the No. 2 water hose clamp bracket to the intake manifold with the bolt.
Using an 8 mm socket wrench, install the wire harness clamp bracket to the intake manifold with the bolt.
16264D
6.CONNECT NO. 2 WATER BY-PASS HOSE
Engage the clamp to connect the No. 2 water by-pass hose to the No. 2 water hose clamp bracket.
16279
7.CONNECT NO. 3 WATER BY-PASS PIPE
Using an 8 mm socket wrench, connect the No. 3 water by-pass pipe to the intake manifold with the bolt.
Connect the water by-pass hose to the No. 3 water by-pass pipe and slide the clip to secure it.
8.CONNECT ENGINE WIRE
Engage the clamp to connect the engine wire to the intake manifold.
Connect the engine wire to the intake manifold with the bolt.
Engage the 3 clamps to connect the engine wire to the intake manifold and fuel vapor feed pipe.
Connect the engine wire to the fuel delivery guard, intake manifold and timing chain cover assembly with the 3 bolts.
Connect the 2 connectors.
Connect the fuel vapor feed hose to the No. 1 vacuum switching valve assembly.
23827D
9.CONNECT NO. 1 FUEL VAPOR FEED HOSE
Engage the clamp to connect the No. 1 fuel vapor feed hose.
Connect the No. 1 fuel vapor feed hose to the intake manifold and slide the hose clip to secure it.
89421
10.INSTALL E.F.I. VACUUM SENSOR ASSEMBLY (MANIFOLD ABSOLUTE PRESSURE SENSOR)
25601
11.INSTALL NO. 1 EGR PIPE SUB-ASSEMBLY
22030
12.INSTALL THROTTLE BODY WITH MOTOR ASSEMBLY
17751
13.INSTALL NO. 1 AIR CLEANER INLET
53141F
14.INSTALL RADIATOR COVER