Home › Engine / Hybrid System › M20A-FXS (ENGINE CONTROL) › KNOCK SENSOR › from 2019.09
RM32K0E _51 Engine / Hybrid System _083960 M20A-FXS ENGINE CONTROL _0404842 KNOCK SENSOR A

M20A-FXS ENGINE CONTROL  KNOCK SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during knock sensor removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
for M20A-FXS
·

Replacement of throttle body assembly

·

Cleaning the deposits from the throttle body assembly

·

Air leak from intake system is repaired


Inspection After Repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

PROCEDURE

Hide 89615 2.REMOVE KNOCK SENSOR

a.
A406047

Disconnect the knock sensor connector.


b.

Remove the bolt and knock sensor from the cylinder block sub-assembly.

NOTICE:

If the knock sensor has been struck or dropped, replace it.