Home › Engine / Hybrid System › M20A-FXS (ENGINE CONTROL) › AIR FUEL RATIO SENSOR (for Sensor 2) › from 2019.09
RM32K0E _51 Engine / Hybrid System _083960 M20A-FXS ENGINE CONTROL _0404844 AIR FUEL RATIO SENSOR(for Sensor 2) A

M20A-FXS ENGINE CONTROL  AIR FUEL RATIO SENSOR(for Sensor 2)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during air fuel ratio sensor removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
for M20A-FXS
·

Replacement of air fuel ratio sensor (sensor 2)

·

Gas leak from exhaust system is repaired


Inspection After Repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

CAUTION:
·
A344784

When the engine is hot, do not touch high-temperature areas such as the engine or exhaust pipe.

·

Touching high-temperature areas such as the engine and exhaust pipe could result in burns.



PROCEDURE

Hide 17410 1.REMOVE FRONT EXHAUST PIPE ASSEMBLY

Hide 89467C 2.REMOVE AIR FUEL RATIO SENSOR

a.
A396246

Disengage the wire harness clamp.


b.

Remove the wire harness clamp bracket from the air fuel ratio sensor.


c.
A396247N01
0.938,0.854 0.75,0.375 false 0.479,0.302 0.938,0.5 0.458,0.198 10 false SST

Using SST, remove the air fuel ratio sensor from the front exhaust pipe assembly (TWC: Front and Rear Catalyst).

SST
09224-00012  

NOTICE:

If the air fuel ratio sensor has been struck or dropped, replace it.