Home › Engine / Hybrid System › M20A-FXS (INTAKE / EXHAUST) › EXHAUST PIPE › from 2019.09
RM32K0E _51 Engine / Hybrid System _083957 M20A-FXS INTAKE / EXHAUST _0404364 EXHAUST PIPE A

M20A-FXS INTAKE / EXHAUST  EXHAUST PIPE  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during front exhaust pipe assembly and tail exhaust pipe assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
·

Replacement of exhaust pipe assembly

·

Gas leak from exhaust system is repaired


Inspection After Repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

CAUTION:
A344784

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.


PROCEDURE

Hide 58165B 2.REMOVE FRONT FLOOR COVER RH

HINT:

Perform the same procedure as for the front floor cover LH.


Hide 57533B 3.REMOVE FRONT FLOOR CENTER BRACE

Hide 17430 4.REMOVE TAIL EXHAUST PIPE ASSEMBLY

CAUTION:

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.


a.
A450898

Remove the 2 bolts and 2 compression springs and disconnect the tail exhaust pipe assembly from the front exhaust pipe assembly.


b.

Remove the tail exhaust pipe assembly from the 4 exhaust pipe supports.


c.

Remove the exhaust pipe gasket from the front exhaust pipe assembly.


Hide 17410 5.REMOVE FRONT EXHAUST PIPE ASSEMBLY

CAUTION:

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.


a.
A450899

Remove the 2 bolts and 2 compression springs and disconnect the front exhaust pipe assembly from the exhaust manifold.


b.

Remove the front exhaust pipe assembly from the 2 exhaust pipe supports.


c.

Remove the exhaust pipe gasket from the exhaust manifold.