Home › Engine / Hybrid System › M20A-FXS (COOLING) › WATER PUMP › from 2019.09
RM32K0E _51 Engine / Hybrid System _084057 M20A-FXS COOLING _0404850 WATER PUMP A

M20A-FXS COOLING  WATER PUMP  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:

This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

Hide 16032 1.INSTALL ENGINE WATER PUMP ASSEMBLY (WATER INLET HOUSING)

a.

Install a new gasket to the engine water pump assembly (water inlet housing).

HINT:

Be sure to clean the contact surfaces.



b.

Install the engine water pump assembly (water inlet housing) to the cylinder block sub-assembly with the 4 bolts.

Torque:
43 N*m (438 kgf*cm, 32 ft.*lbf)


Hide 16031 2.INSTALL WATER INLET WITH THERMOSTAT SUB-ASSEMBLY