Home › Engine / Hybrid System › M20A-FXS (COOLING) › COOLING FAN MOTOR › from 2019.09
RM32K0E _51 Engine / Hybrid System _084057 M20A-FXS COOLING _0404852 COOLING FAN MOTOR A

M20A-FXS COOLING  COOLING FAN MOTOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during cooling fan motor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function When Necessary Procedures are not Performed Link
Front bumper assembly
·

Measurement of ultrasonic sensor detection angle

·

Ultrasonic sensor detection angle registration


Parking Support Brake System (Click here)
Simple intelligent parking assist system
Front television camera view adjustment Panoramic View Monitor System (Click here)

PROCEDURE

Hide 16400 1.REMOVE RADIATOR ASSEMBLY

Hide 16361J 2.REMOVE FAN RH

a.
A432828

Remove the 3 screws and fan RH from the cooling fan motor RH.


Hide 16361K 3.REMOVE FAN LH

a.
A432829

Remove the 3 screws and fan LH from the cooling fan motor LH.


Hide 16364A 4.DISCONNECT COOLING FAN WIRE

a.
A432824

Disengage the 3 clamps to disconnect the cooling fan wire from the fan shroud.


b.

Lift up the lever to disengage the lock, and disconnect the cooling fan wire connector from the cooling fan motor RH.


Hide 16363G 5.REMOVE COOLING FAN MOTOR LH

a.
A432826

Remove the 3 screws and cooling fan motor LH from the fan shroud.


Hide 16363F 6.REMOVE COOLING FAN MOTOR RH

a.
A432827

Remove the 3 screws and cooling fan motor RH from the fan shroud.