23221
1.INSTALL FUEL PUMP
Perform "Inspection After Repair" after replacing the fuel pump.
Click hereEngine / Hybrid System>M20A-FXS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION
Apply gasoline to a new O-ring. Then install the O-ring to the fuel pump.
Engage the 3 claws to install the fuel pump to the No. 1 fuel suction support.
Securely engage the claws.
Engage the 4 claws to install the fuel pump to the fuel sub-tank sub-assembly.
Securely engage the claws.
| *a | Protrusion |
| *b | Installation Hole |
|
Slide |
Align the protrusion of the fuel sub-tank sub-assembly with the installation hole of the fuel suction plate sub-assembly and then slide the fuel suction plate sub-assembly to install the fuel sub-tank sub-assembly.
Engage the clamp to connect the fuel pump harness to the fuel suction tube with pump and gauge assembly.
Do not damage the wire harness.
When engaging each wire harness to the clamp, engage one wire at a time.
Connect the 2 fuel pump harness connectors.
83320
2.INSTALL FUEL SENDER GAUGE ASSEMBLY