Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT ASSEMBLY (for Single Beam Headlight) › from 2019.09
RM32K0E _59 Vehicle Exterior _061162 LIGHTING (EXT) _0406613 HEADLIGHT ASSEMBLY(for Single Beam Headlight) A

LIGHTING (EXT)  HEADLIGHT ASSEMBLY(for Single Beam Headlight)  REASSEMBLY  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 81134 1.INSTALL HEADLIGHT GASKET

Hide 89907 2.INSTALL HEADLIGHT ECU SUB-ASSEMBLY

Hide 81194A 3.INSTALL HEADLIGHT PROTECTOR

a.

Clean the headlight assembly surface.

i.

Remove the double-sided tape from the headlight assembly surface.


ii.

Wipe off any tape adhesive residue with cleaner.



b.

Remove the peeling paper from a new headlight protector.

HINT:

After removing the peeling paper, keep the exposed adhesive free from foreign matter.



c.
E420064

Install the headlight protector.

NOTICE:

Make sure to apply sufficient pressure to the portions with double-sided tape of the headlight protector to ensure the tape is securely adhered.