The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced the during headlight ECU sub-assembly removal/installation are shown below.
If the headlight ECU sub-assembly RH is replaced with a new one, vehicle information registration and initialization are not necessary.
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1.REMOVE HEADLIGHT ASSEMBLY
89907
2.REMOVE HEADLIGHT ECU SUB-ASSEMBLY
Make sure to replace the headlight gasket with a new one. Failure to do so may cause water ingress.
Remove the 3 screws.
Disconnect the connector cover from the headlight ECU sub-assembly.
for TMMT Made:
Disconnect the 2 connectors to remove the headlight ECU sub-assembly.
If the headlight ECU sub-assembly has been struck or dropped, replace it with a new one.
for TMC Made:
Disconnect the connector to remove the headlight ECU sub-assembly.
If the headlight ECU sub-assembly has been struck or dropped, replace it with a new one.
81134
3.REMOVE HEADLIGHT GASKET
Make sure to replace the headlight gasket with a new one. Failure to do so may cause water ingress.
Remove the headlight gasket.