Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT ASSEMBLY (for Single Beam Headlight) › 2019.09–2020.08
RM32K0E _59 Vehicle Exterior _061162 LIGHTING (EXT) _0406613 HEADLIGHT ASSEMBLY(for Single Beam Headlight) A

LIGHTING (EXT)  HEADLIGHT ASSEMBLY(for Single Beam Headlight)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced the during headlight assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*1: When performing learning using the GTS.

Click here(Click here)

Disconnect cable from negative auxiliary battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Toyota parking assist-sensor system*1
Parking support brake system*1
Simple intelligent parking assist system*1
Pre-collision system
Memorize steering angle neutral point Panoramic view monitor system (Click here)
Initialize back door lock Power door lock control system (Click here)
Headlight ECU sub-assembly LH
·

Synchronize vehicle information

·

Initialize headlight ECU sub-assembly LH


Automatic headlight beam level control system (Click here)

NOTICE:

If the headlight ECU sub-assembly RH is replaced with a new one, vehicle information registration and initialization are not necessary.


HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 3.REMOVE FRONT BUMPER ASSEMBLY

Hide 85319A 4.SEPARATE INLET HOSE (for RH Side)

E436576

a.

Remove the clip to separate the inlet hose.


Hide 5.REMOVE HEADLIGHT ASSEMBLY

a.
E420060C01
0,0 0,0 false
V100155

Protective Tape


Apply protective tape around the headlight assembly as shown in the illustration.


b.
E420071C02
0.552,2.99 0.625,2.719 true 0.375,2.969 0.583,3.167 0.208,0.198 10 true *a 3.063,1.927 3.25,2.115 0.188,0.188 12 true A 3.083,2.865 3.271,3.052 0.188,0.188 12 true B
*a Connector Lock Lever
V113147

Remove in this Direction


Disconnect the connector A.


c.

Disengage the claw, pull down the connector lock lever as shown in the illustration to disconnect the connector B.


d.
E420062

Remove the bolt and 3 screws.


e.
E420063C01
0,0 0,0 false
V113147

Remove in this Direction


Remove the headlight assembly as shown in the illustration.