The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel tank assembly removal/installation are shown below.
*1: When performing learning using the GTS.
Never perform work on fuel system components near any possible ignition sources.
Vaporized fuel could ignite, resulting in a serious accident.
77020A
1.REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY
2.DRAIN FUEL
17430
3.REMOVE TAIL EXHAUST PIPE ASSEMBLY
57628C
4.REMOVE REAR FLOOR SIDE MEMBER COVER LH
Remove the 3 bolts and clip (A).
Disengage the clip (B) to remove the rear floor side member cover LH.
57627A
5.REMOVE REAR FLOOR SIDE MEMBER COVER RH
Remove the 3 bolts.
Disengage the clip to remove the rear floor side member cover RH.
77641A
6.REMOVE NO. 1 FUEL TANK PROTECTOR
Remove the 4 clips and No. 1 fuel tank protector from the fuel tank assembly.
7.DISCONNECT CHARCOAL CANISTER OUTLET HOSE
Slide the clip and disconnect the charcoal canister outlet hose from the fuel tank filler pipe sub-assembly.
77213E
8.DISCONNECT FUEL TANK TO FILLER PIPE HOSE
Loosen the clamp, then disconnect the fuel tank to filler pipe hose from the fuel tank assembly.
9.DISCONNECT NO. 1 FUEL EVAPORATION TUBE SUB-ASSEMBLY
Slide the clip and disconnect the No. 1 fuel evaporation tube sub-assembly from the fuel pipe.
77209F
10.DISCONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY
Disconnect the fuel tank main tube sub-assembly from the fuel pipe.
Click hereEngine / Hybrid System>2ZR-FXE (FUEL)>FUEL SYSTEM>PRECAUTION
77100
11.REMOVE FUEL TANK ASSEMBLY
The fuel tank assembly is very heavy. Be sure to follow the procedure described in the repair manual, or the fuel tank assembly may fall off the engine lifter.
Disconnect the fuel tank breather tube from the fuel tank filler pipe sub-assembly.
Click hereEngine / Hybrid System>2ZR-FXE (FUEL)>FUEL SYSTEM>PRECAUTION
Support the fuel tank assembly using an engine lifter.
Using height adjustment attachments and plate lift attachments, keep the fuel tank assembly horizontal.
Remove the 4 bolts.
Lower the engine lifter to remove the fuel tank assembly.
Be careful not to drop the fuel tank assembly.
When removing the fuel tank assembly, tilt it slightly to prevent it from interfering with the surrounding parts.
Remove the fuel tank side plate from the fuel tank assembly.
12.REMOVE NO. 1 FUEL EVAPORATION TUBE SUB-ASSEMBLY
Disengage the 3 clamps to remove the No. 1 fuel evaporation tube sub-assembly from the fuel tank assembly.
77209F
13.REMOVE FUEL TANK MAIN TUBE SUB-ASSEMBLY
Disengage the 3 clamps to remove the fuel tank main tube sub-assembly from the fuel tank assembly.
14.REMOVE CHARCOAL CANISTER OUTLET HOSE
Disengage the 2 clamps to remove the charcoal canister outlet hose from the fuel tank assembly.