Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE PEDAL (for RHD) › 2019.09–2020.08
RM32K0E _54 Brake _060045 BRAKE SYSTEM (OTHER) _0299582 BRAKE PEDAL(for RHD) A

BRAKE SYSTEM (OTHER)  BRAKE PEDAL(for RHD)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during brake pedal support assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*1: When performing learning using the GTS.

Click here(Click here)

Auxiliary battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Toyota parking assist-sensor system*1
Parking support brake system*1
Simple intelligent parking assist system*1
Pre-collision system
Memorize steering angle neutral point Panoramic view monitor system (Click here)
Initialize back door lock Power door lock control system (Click here)
Replacement of brake pedal support assembly
1.

Clear the data stored during previous linear solenoid valve offset learning, ABS holding solenoid valve learning, brake pedal stroke sensor assembly zero point calibration and system information memorization.

2.

Perform linear solenoid valve offset learning, ABS holding solenoid valve learning, brake pedal stroke sensor assembly zero point calibration and system information memorization.


·

DTCs are stored

·

ABS warning light illuminates

·

Brake warning light/yellow (minor malfunction) illuminates

·

Slip indicator light illuminates

·

VSC disabled or malfunctions


for Initialization:(Click here)
for Calibration:(Click here)

NOTICE:

While the auxiliary battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or any door courtesy switch turns on. Therefore, when servicing the brake system components, do not operate the brake pedal or open/close the doors while the auxiliary battery is connected.


PROCEDURE

Hide 55401E 1.REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

Hide 89510D 2.REMOVE BRAKE PEDAL STROKE SENSOR ASSEMBLY

Hide 84340 3.REMOVE STOP LIGHT SWITCH ASSEMBLY

Hide 84345 4.REMOVE STOP LIGHT SWITCH MOUNTING ADJUSTER

Hide 47101A 5.REMOVE BRAKE PEDAL RETURN SPRING

a.
C366615

Remove the brake pedal return spring from the brake pedal support assembly and push rod pin.


Hide 47264A 6.REMOVE PUSH ROD PIN

a.
C366616

Remove the clip and push rod pin to separate the brake pedal support assembly from the brake master cylinder push rod clevis.


Hide 47110 7.REMOVE BRAKE PEDAL SUPPORT ASSEMBLY

a.
C366617

Disengage the clamp to separate the wire harness from the brake pedal support assembly.


b.
C366618

Remove the bolt and separate the brake pedal support assembly from the instrument panel reinforcement assembly.


c.
C366619

Remove the 2 clips.


d.

Remove the 4 nuts and brake pedal support assembly.


e.
C366620

Remove the nut from the brake pedal support assembly.


Hide 47121 8.REMOVE BRAKE PEDAL PAD

a.

Remove the brake pedal pad from the brake pedal support assembly.