Home › Power Source / Network › M20A-FXS (BATTERY / CHARGING) › CHARGING SYSTEM › from 2019.09
RM32K0E _57 Power Source / Network _084047 M20A-FXS BATTERY / CHARGING _0404934 CHARGING SYSTEM D

M20A-FXS BATTERY / CHARGING  CHARGING SYSTEM  DIAGNOSIS SYSTEM  


DESCRIPTION


a.

The hybrid vehicle control ECU has a self-diagnosis system. If the computer, hybrid control system or a component is not working properly, the ECU records the conditions that relate to the fault. The ECU also illuminates the master warning light in the combination meter assembly and provides other appropriate messages on the multi-information display, such as the HV system warning message, HV battery warning message, or discharge warning message.

HINT:

The master warning light will illuminate when the hybrid battery system is malfunctioning and the light will blink when in inspection mode.




FREEZE FRAME DATA


The hybrid vehicle control ECU records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can be helpful in determining whether the vehicle was running or stopped, whether the engine was warmed up or not, as well as other data recorded at the time of a malfunction.



AUXILIARY BATTERY VOLTAGE


Standard Voltage:
Switch Condition Specified Condition
Power switch on (IG) 11 to 14 V


If the voltage is below 11 V, replace or recharge the auxiliary battery.

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION




MIL (Malfunction Indicator Lamp)


a.

The MIL is illuminated when the power switch is first turned on (IG), before the READY light comes on.


b.

When the READY light turns on, the MIL should turn off. If the MIL remains illuminated, the diagnosis system has detected a malfunction or abnormality in the system.

HINT:

If the MIL is not illuminated when the power switch is first turned on (IG), check the MIL circuit.

for SFI System

Click hereEngine / Hybrid System>M20A-FXS (ENGINE CONTROL)>SFI SYSTEM>MIL Circuit