Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM › 2019.09–2020.08
RM32K0E _51 Engine / Hybrid System _061336 CRUISE CONTROL _0304571 DYNAMIC RADAR CRUISE CONTROL SYSTEM C

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  C1A52  Radar Cruise Control Presence Determination Malfunction (Engine / HV)  


DESCRIPTION

DTC C1A52 is stored when the hybrid vehicle control ECU cannot recognize the millimeter wave radar sensor assembly.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1A52 Radar Cruise Control Presence Determination Malfunction (Engine / HV) Approximately 17 seconds after the power switch is turned on (IG) the hybrid vehicle control ECU cannot recognize the millimeter wave radar sensor assembly for approximately 1.3 seconds or more.
·

Hybrid vehicle control ECU

·

Millimeter wave radar sensor assembly



CAUTION / NOTICE / HINT

NOTICE:

When replacing the millimeter wave radar sensor assembly, always replace it with a new one. If a millimeter wave radar sensor assembly which was installed to another vehicle is used, the information stored in the millimeter wave radar sensor assembly will not match the information from the vehicle. As a result, a DTC may be stored.


PROCEDURE

1.CHECK FOR DTC (RADAR CRUISE 2)
a.

Clear the DTCs.

Click hereEngine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR

Powertrain > Radar Cruise2 > Clear DTCs
50002 197

b.

Make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.

1.

Turn the power switch on (IG).

2.

Wait for 20 seconds or more.




c.

Check for DTCs.

Click hereEngine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR

Powertrain > Radar Cruise2 > Trouble Codes
50001 197

Result:
Result Proceed to
DTC C1A52 is not output A
DTC C1A52 is output B



A

B

2.REPLACE HYBRID VEHICLE CONTROL ECU
2.REPLACE HYBRID VEHICLE CONTROL ECU

NEXT

3.CHECK FOR DTC (RADAR CRUISE 2)
3.CHECK FOR DTC (RADAR CRUISE 2)
a.

Clear the DTCs.

Click hereEngine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR

Powertrain > Radar Cruise2 > Clear DTCs
50002 197

b.

Make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.

1.

Turn the power switch on (IG).

2.

Wait for 20 seconds or more.




c.

Check for DTCs.

Click hereEngine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR

Powertrain > Radar Cruise2 > Trouble Codes
50001 197

Result:
Result Proceed to
DTC C1A52 is not output A
DTC C1A52 is output B



A

END (HYBRID VEHICLE CONTROL ECU WAS DEFECTIVE)

B

REPLACE MILLIMETER WAVE RADAR SENSOR ASSEMBLY