The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are replaced during millimeter wave radar sensor assembly removal/installation are shown below.
1.REMOVE FRONT BUMPER ASSEMBLY
88215
2.REMOVE NO. 1 MILLIMETER WAVE RADAR SENSOR BRACKET
Remove the 2 bolts.
Disengage the guide and remove the millimeter wave radar sensor bracket.
3.REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY
|
Bolt |
|
Screw |
Remove the 2 bolts and screw.
Disengage the 2 guides and remove the millimeter wave radar sensor assembly.
Do not reuse the millimeter wave radar sensor assembly if it has been dropped or subjected to a severe impact.