Home › Audio / Visual / Telematics › AUDIO / VIDEO › NOISE FILTER › from 2019.09
RM32K0E _56 Audio / Visual / Telematics _061817 AUDIO / VIDEO _0303541 NOISE FILTER A

AUDIO / VIDEO  NOISE FILTER  REMOVAL  


PROCEDURE

Hide 64330D 1.REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY (w/ Package Tray Trim)

Hide 64910J 2.REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)

Hide 58410B 3.REMOVE DECK BOARD ASSEMBLY

Hide 64777J 4.REMOVE SPARE WHEEL CUSHION (for 2ZR-FXE)

Hide 64997 5.REMOVE DECK FLOOR BOX LH (w/ Deck Floor Box)

Hide 64995 6.REMOVE DECK FLOOR BOX RH (w/ Deck Floor Box)

Hide 64429B 7.REMOVE LUGGAGE ROOM BOX (for M20A-FXS with Spare Tire)

Hide 8.REMOVE SPARE TIRE (for M20A-FXS with Spare Tire)

Hide 58440 9.REMOVE BATTERY SERVICE HOLE COVER ASSEMBLY (for M20A-FXS without Spare Tire)

Hide 64991 10.REMOVE DECK FLOOR FRONT BOX (for M20A-FXS without Spare Tire)

Hide 11.REMOVE BENCH TYPE REAR SEAT CUSHION ASSEMBLY

Hide 67918A 12.REMOVE REAR DOOR SCUFF PLATE LH

Hide 62332A 13.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH

Hide 71304C 14.REMOVE REAR SEATBACK HINGE SUB-ASSEMBLY LH

Hide 76974F 15.REMOVE REAR UNDER SIDE COVER LH

Hide 62552F 16.REMOVE REAR SEAT SIDE GARNISH LH

Hide 64716D 17.REMOVE DECK TRIM REAR COVER

Hide 18.REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY (w/ Luggage Compartment Room Light)

Hide 64715C 19.REMOVE DECK TRIM SIDE COVER LH (w/ Cover)

Hide 64740C 20.REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH

Hide 86011A 21.REMOVE RADIO SETTING CONDENSER

NOTICE:

When the terminal cover is removed, the radio setting condenser must be replaced because the terminal cover and condenser are supplied as a set.


a.
E353825

Remove the bolt.


b.

Disengage the clamp to disconnect the radio setting condenser with wire harness from the vehicle body.


c.
E290012

Disengage the claw to pull out the cover as shown in the illustration.


d.
E290013

Using a screwdriver, disengage the 6 claws to remove the 2 terminal covers with wire harness from the radio setting condenser.


e.
E290011

Using a screwdriver, bend back and break off the claw as shown in the illustration.


f.

Remove the terminal cover from the wire harness.

NOTICE:
·

Make sure to hold the crimping side of the terminal when disconnecting the wire harness from the terminal cover.

·

Make sure not to bend the exposed wire when disconnecting the wire harness from the terminal cover.

·

Check for deformation of the terminal after the wire harness has been removed from the terminal cover.