Home › Engine / Hybrid System › 2ZR-FXE (ENGINE CONTROL) › AIR FUEL RATIO SENSOR › from 2019.09
RM32K0E _51 Engine / Hybrid System _060312 2ZR-FXE ENGINE CONTROL _0295709 AIR FUEL RATIO SENSOR A

2ZR-FXE ENGINE CONTROL  AIR FUEL RATIO SENSOR  INSTALLATION  


PROCEDURE

Hide 89467B 1.INSTALL AIR FUEL RATIO SENSOR

HINT:

Perform "Inspection After Repair" after replacing the air fuel ratio sensor.

Click hereEngine / Hybrid System>2ZR-FXE (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION


a.
A394215C01
0.615,1.563 0.958,1.646 true 0.979,0.229 1.177,0.448 0.198,0.219 10 true *a 0.167,1.438 0.563,1.656 0.396,0.219 10 true SST
*a Torque Wrench Fulcrum Length


Using SST, install the air fuel ratio sensor to the exhaust manifold (TWC: Front Catalyst).

SST
09224-00012  

Torque:
Specified tightening torque : 44 N*m (449 kgf*cm, 32 ft.*lbf)

NOTICE:

If the air fuel ratio sensor has been struck or dropped, replace it.


HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 255 mm (10.0 in.)):

39 N*m (398 kgf*cm, 29 ft.*lbf)




b.

Engage the 2 wire harness clamps.


c.

Connect the air fuel ratio sensor connector.


Hide 55701J 2.INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY (for LHD)

Hide 55701J 3.INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY (for RHD)

Hide 55736D 4.INSTALL COWL BODY MOUNTING REINFORCEMENT LH

Hide 55735C 5.INSTALL COWL BODY MOUNTING REINFORCEMENT RH

Hide 55735A 6.INSTALL WATER GUARD PLATE LH (for TMC Made RHD)

Hide 55737B 7.INSTALL NO. 1 HEATER AIR DUCT SPLASH SHIELD SEAL

Hide 8.INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

Hide 10.PERFORM INITIALIZATION

a.

Perform "Inspection After Repair" after replacing an air fuel ratio sensor.

Click hereEngine / Hybrid System>2ZR-FXE (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION