When checking for DTCs, make sure that the blind spot monitor system is turned on.
Inspect the fuses for circuits related to this system before performing the following procedure.
Turn the power switch off.
Turn the power switch on (IG).
Recheck for DTCs and check if the same DTC is output again.
No DTCs are output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Front view of wire harness connector
(to Blind Spot Monitor Sensor RH(Slave)) |
| *b | Front view of wire harness connector
(Blind Spot Monitor Sensor RH (Slave)) |
Disconnect the M64 RCTA buzzer (blind spot monitor buzzer) connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| M64-1 (BZP) - Body ground | Power switch on (IG) | 11 to 14 V |
| M64-2 (BZN) or M63-3 (BUZ) - Body ground | Below 1 V | |
| M64-2 (BZN) - M64-1 (BZP) | Below 1 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Front view of wire harness connector
(to RCTA Buzzer (Blind Spot Monitor Buzzer)) |
| *b | Front view of wire harness connector
(to Blind Spot Monitor Sensor RH(Slave)) |
Disconnect the M64 RCTA buzzer (blind spot monitor buzzer) connector.
Disconnect the M63 blind spot monitor sensor RH (Slave) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| M64-2 (BZN) - M63-3 (BUZ) | Always | Below 1 Ω |
| M64-2 (BZN) or M63-3 (BUZ) - Body ground | Always | 10 kΩ or higher |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| M64-2 (BZN) or M63-3 (BUZ) - Body ground | Power switch on (IG) | Below 1 V |
| M64-1 (BZP) - Body ground | Power switch on (IG) | 11 to 14 V |
| M64-1 (BZP) - Body ground | Power switch off | Below 1 V |
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>REAR CROSSING TRAFFIC ALERT BUZZER>REMOVAL
NG