The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the blind spot monitor buzzer removal/installation are shown below.
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
If the front seat airbag assembly has been deployed, replace the front seat airbag assembly, front seatback frame sub-assembly, separate type front seatback pad and separate type front seatback cover with the necessary parts in accordance with the extent of the collision damage.
After the power switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the power switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.
Use the same procedure for LHD and RHD vehicles.
The procedure listed below is for the LHD vehicles.
73900
1.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (for LHD with Driver Side Knee Airbag)
55545
2.REMOVE FUSE BOX OPENING COVER (for LHD without Driver Side Knee Airbag)
55550
3.REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY (for RHD)
89747F
4.REMOVE BLIND SPOT MONITOR BUZZER
for LHD:
Using a clip remover, disengage the clamp.
Disconnect the connector to remove the blind spot monitor buzzer.
for RHD:
Using a clip remover, disengage the clamp.
Disconnect the connector to remove the blind spot monitor buzzer.