Home › Engine / Hybrid System › 2ZR-FXE (COOLING) › WATER PUMP › 2019.09–2020.08
RM32K0E _51 Engine / Hybrid System _060780 2ZR-FXE COOLING _0298026 WATER PUMP A

2ZR-FXE COOLING  WATER PUMP  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during engine water pump assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*1: When performing learning using the GTS.

Click here(Click here)

Disconnect cable from negative auxiliary battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Toyota parking assist-sensor system*1
Parking support brake system*1
Simple intelligent parking assist system*1
Pre-collision system
Memorize steering angle neutral point Panoramic view monitor system (Click here)
Initialize back door lock Power door lock control system (Click here)
Replacement of inverter with converter assembly Resolver learning
·

DTCs are stored

·

Slight vibration at a vehicle speed of 5 km/h (3 mph) or less

·

Shock or vibration during acceleration


for 2ZR-FXE (for Nickel Metal Hydride Battery):(Click here)
for 2ZR-FXE (for Lithium-ion Battery):(Click here)
for 2ZR-FXE

Replacement of ECM


Perform Vehicle Identification Number (VIN) registration MIL comes on (Click here)
for 2ZR-FXE
·

Replacement of throttle body assembly

·

Replacement of engine assembly

·

Gas leak from exhaust system is repaired


Inspection After Repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)
Suspension, tires, etc.
(The vehicle height changes because of suspension or tire replacement)
Initialize headlight ECU sub-assembly LH Automatic headlight beam level control system (Click here)
Front wheel alignment adjustment
1.

Clear zero point calibration data.

2.

Perform yaw rate and acceleration sensor zero point calibration.


·

DTCs are stored

·

ABS warning light illuminates

·

Brake warning light/yellow (minor malfunction) illuminates

·

Slip indicator light illuminates

·

VSC disabled or malfunctions


for Initialization:(Click here)
for Calibration:(Click here)
Replacement of hybrid vehicle transaxle assembly
·

Resolver learning

·

Initialize resolver


·

DTCs are stored

·

Slight vibration at a vehicle speed of 5 km/h (3 mph) or less

·

Shock or vibration during acceleration


for 2ZR-FXE (for Nickel Metal Hydride Battery):(Click here)
for 2ZR-FXE (for Lithium-ion Battery):(Click here)

PROCEDURE

Hide 1.REMOVE ENGINE ASSEMBLY WITH TRANSAXLE

Hide 16100 2.REMOVE ENGINE WATER PUMP ASSEMBLY

a.

Disconnect the engine water pump assembly connector.


b.
A375603

Remove the 5 bolts and engine water pump assembly from the timing chain cover sub-assembly.


c.
A375604

Remove the gasket from the engine water pump assembly.