Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM › from 2019.09
RM32K0E _59 Vehicle Exterior _061162 LIGHTING (EXT) _0303092 AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM Y

LIGHTING (EXT)  AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM  HOW TO PROCEED WITH TROUBLESHOOTING  


CAUTION / NOTICE / HINT

HINT:
·

Use the following procedure to troubleshoot the automatic headlight beam level control system.


·

*: Use the GTS.



PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.CUSTOMER PROBLEM ANALYSIS AND SYMPTOM CHECK
2.CUSTOMER PROBLEM ANALYSIS AND SYMPTOM CHECK
Result:
Proceed to
NEXT



NEXT

3.INSPECT BATTERY VOLTAGE
3.INSPECT BATTERY VOLTAGE
a.

Measure the battery voltage.

Standard Voltage:

11 to 14 V (power switch off)



If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

Result:
Proceed to
NEXT



NEXT

4.INSPECT CAN COMMUNICATION SYSTEM
4.INSPECT CAN COMMUNICATION SYSTEM
a.

Use the GTS to check if the CAN communication system is functioning normally.

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM


Result:
Result Proceed to
CAN communication system DTCs are not output A
CAN communication system DTCs are output B



A

5.CHECK FOR DTC* (LIGHTING SYSTEM)

B

5.CHECK FOR DTC* (LIGHTING SYSTEM)
a.

Connect the GTS to the DLC3.


b.

Turn the power switch to on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Main body or AFS / Trouble Codes.


e.

Check for DTCs.

Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM (w/ Headlight ECU)>DTC CHECK / CLEAR

Body Electrical > Main Body > Trouble Codes
50001 123
Body Electrical > AFS > Trouble Codes
50001 165

Result:
Result Proceed to
DTCs are not output A
DTCs are output B



A

6.CHECK FOR DTC* (AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM)

B

GO TO DIAGNOSTIC TROUBLE CODE CHART (LIGHTING SYSTEM)

6.CHECK FOR DTC* (AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM)
a.

Connect the GTS to the DLC3.


b.

Turn the power switch to on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / AFS / Trouble Codes.

Body Electrical > AFS > Trouble Codes
50001 165


Result:
Result Proceed to
DTCs are not output A
DTCs are output B



A

7.PROBLEM SYMPTOMS TABLE

B

GO TO DIAGNOSTIC TROUBLE CODE CHART (AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM)

7.PROBLEM SYMPTOMS TABLE

Result:
Result Proceed to
Fault is not listed in Problem Symptoms Table A
Fault is listed in Problem Symptoms Table B



A

8.OVERALL ANALYSIS AND TROUBLESHOOTING*

B

8.OVERALL ANALYSIS AND TROUBLESHOOTING*

NEXT

9.ADJUST, REPAIR OR REPLACE
9.ADJUST, REPAIR OR REPLACE
Result:
Proceed to
NEXT



NEXT

10.CONFIRMATION TEST
10.CONFIRMATION TEST
Result:
Proceed to
NEXT



NEXT

END