The headlight unit (headlight leveling motor) receives a signal from the headlight control ECU sub-assembly to operate. The headlight control ECU sub-assembly receives a signal indicating the operating conditions of the headlight unit (headlight leveling motor).
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|
| B2417 | Headlight Beam Level Control Motor LH Malfunction | Malfunction in headlight leveling motor LH | ·
Headlight ECU sub-assembly LH ·
Headlight Unit Assembly LH (Headlight Leveling Motor) |
- |
| B2418 | Headlight Beam Level Control Motor RH Malfunction | Malfunction in headlight leveling motor RH | ·
Headlight ECU sub-assembly RH ·
Headlight Unit Assembly RH (Headlight Leveling Motor) |
- |
After the headlight ECU sub-assembly LH is replaced, vehicle information registration and initialization are necessary.
Click hereVehicle Exterior>LIGHTING (EXT)>AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM>INITIALIZATION
Clear the DTCs.
Click hereVehicle Exterior>LIGHTING (EXT)>AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| NEXT |
NEXT
Turn the power switch to on (IG).
Turn on the headlights using the headlight dimmer switch.
Check for DTCs.
Click hereVehicle Exterior>LIGHTING (EXT)>AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM>DTC CHECK / CLEAR
DTC B2417 and B2418 are not output.
| Result | Proceed to |
|---|---|
| OK | A |
| DTC B2417 output occurs | B |
| DTC B2418 output occurs | C |
A
B
C