Home › General › MAINTENANCE › 2ZR-FXE SPARK PLUG › from 2019.09
RM32K0E _V1 General _059911 MAINTENANCE _0299524 2ZR-FXE SPARK PLUG A

MAINTENANCE  2ZR-FXE SPARK PLUG  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during ignition coil assembly or spark plug removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
·

Replacement of ignition coil assembly

·

Replacement of spark plug


Inspection After Repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

PROCEDURE

Hide 1.REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

Hide 55737B 2.REMOVE NO. 1 HEATER AIR DUCT SPLASH SHIELD SEAL

Hide 55735A 3.REMOVE WATER GUARD PLATE LH (for TMC Made RHD)

Hide 55736D 4.REMOVE COWL BODY MOUNTING REINFORCEMENT LH

Hide 55735C 5.REMOVE COWL BODY MOUNTING REINFORCEMENT RH

Hide 55701J 6.REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY (for LHD)

Hide 55701J 7.REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY (for RHD)

Hide 19100P 9.REMOVE SPARK PLUG

a.
A375026

Remove the 4 spark plugs from the cylinder head sub-assembly.

NOTICE:

If a spark plug has been struck or dropped, replace it.


HINT:

Arrange the removed parts in the correct order.