Home › Engine / Hybrid System › M20A-FXS (FUEL) › FUEL MAIN VALVE › from 2020.08
RM32K0E _51 Engine / Hybrid System _083996 M20A-FXS FUEL _0404503 FUEL MAIN VALVE A

M20A-FXS FUEL  FUEL MAIN VALVE  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·
A360563

Never perform work on fuel system components near any possible ignition sources.

·

Vaporized fuel could ignite, resulting in a serious accident.

·
A360564

Do not perform work on fuel system components without first disconnecting the cable from the negative (-) auxiliary battery terminal.

·

Sparks could cause vaporized fuel to ignite, resulting in a serious accident.



HINT:

When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link

*1: When performing learning using the GTS

Click here(Click here)

Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system
Simple intelligent parking assist system*1
Parking support brake system*1
Toyota parking assist-sensor system*1

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



PROCEDURE

Hide 77020A 1.REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY

Hide 2.REMOVE NO. 2 FUEL SUCTION SUPPORT

a.
A435048

Disengage the 3 claws and remove the No. 2 fuel suction support from the fuel suction tube with pump and gauge assembly.


Hide 23070 3.REMOVE FUEL MAIN VALVE ASSEMBLY

a.
A435049C02
2.948,0.896 2.729,0.896 2.729,0.896 2.375,0.521 true 2.979,0.792 3.313,1.208 0.333,0.417 10 false *a
*a Protective Tape


Using a screwdriver with its tip wrapped with protective tape, remove the fuel main valve assembly from the fuel suction tube with pump and gauge assembly.

NOTICE:

Pull out the fuel main valve assembly carefully because the O-ring is firmly installed between the fuel main valve assembly and the fuel suction tube with pump and gauge assembly.



b.
A434943C03
1.573,0.698 1.854,0.302 false 1.865,0.208 2.177,0.365 0.313,0.156 10 false *1
*1 O-ring


Remove the O-ring from the fuel main valve assembly.