The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during EGR valve assembly removal/installation are shown below.
This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
25680
1.REMOVE EGR COOLER ASSEMBLY
25601
2.REMOVE NO. 1 EGR PIPE SUB-ASSEMBLY
Disconnect the EGR valve assembly connector.
Using an 8 mm socket wrench, remove the 4 bolts and No. 1 EGR pipe sub-assembly from the intake manifold and EGR valve assembly.
Remove the EGR valve adapter gasket from the No. 1 EGR pipe sub-assembly.
Remove the EGR inlet gasket from the intake manifold.
25620
3.REMOVE EGR VALVE ASSEMBLY
| *1 | No. 4 Water By-pass Hose |
| *2 | No. 8 Water By-pass Hose |
Slide the clip and remove the No. 4 water by-pass hose from the EGR valve assembly.
Slide the clip and disconnect the No. 8 water by-pass hose from the EGR valve assembly.
Using the 8 mm socket wrench, remove the 2 bolts and EGR valve assembly.