The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during EGR cooler assembly removal/installation are shown below.
This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
1.DRAIN ENGINE COOLANT (for Engine)
G9200
2.REMOVE INVERTER WITH CONVERTER ASSEMBLY
25680
3.REMOVE EGR COOLER ASSEMBLY
| *1 | No. 4 Water By-pass Hose |
| *2 | No. 3 Water By-pass Hose |
Slide the 2 clips and disconnect the No. 4 water by-pass hose and No. 3 water by-pass hose from the EGR cooler assembly.
Remove the 2 bolts and 3 nuts and EGR cooler assembly from the cylinder head sub-assembly and EGR valve assembly.
Remove the EGR valve gasket from the EGR valve assembly.
Remove the EGR cooler gasket from the EGR cooler assembly.