The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the blind spot monitor buzzer removal/installation are shown below.
When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
73900
1.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (for LHD with Driver Side Knee Airbag)
55545
2.REMOVE FUSE BOX OPENING COVER (for LHD without Driver Side Knee Airbag)
55550
3.REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY (for RHD)
89747F
4.REMOVE BLIND SPOT MONITOR BUZZER
for LHD:
Using a clip remover, disengage the clamp.
Disconnect the connector to remove the blind spot monitor buzzer.
for RHD:
Using a clip remover, disengage the clamp.
Disconnect the connector to remove the blind spot monitor buzzer.