Home › Steering › STEERING COLUMN › STEERING WHEEL › from 2020.08
RM32K0E _55 Steering _061343 STEERING COLUMN _0299714 STEERING WHEEL A

STEERING COLUMN  STEERING WHEEL  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the steering wheel assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative (-) auxiliary battery terminal Memorize steering angle neutral point Panoramic view monitor system (Click here)

HINT:

When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link

*1: When performing learning using the GTS

Click here(Click here)

Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system
Simple intelligent parking assist system*1
Parking support brake system*1
Toyota parking assist-sensor system*1

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



PROCEDURE

Hide 1.ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

Hide 45130 2.REMOVE HORN BUTTON ASSEMBLY

Hide 45100 3.REMOVE STEERING WHEEL ASSEMBLY

a.
C365791

Disconnect the 2 connectors from the spiral cable with sensor sub-assembly.


b.

w/ Steering Heater:

i.
C365800

Disconnect the steering heater connector.



c.
C365792C01
1.698,0.656 0.552,0.604 0.552,0.604 1.708,0.469 true 0.344,0.5 0.656,0.656 0.313,0.156 10 false *a
*a Matchmark


Remove the steering wheel assembly set nut.


d.

Put matchmarks on the steering wheel assembly and steering main shaft.


e.
C365793C01
1.51,2.281 0.698,1.625 true 1.135,2.99 1.448,3.146 0.313,0.156 10 false *a 2.948,2.594 3.26,2.75 0.313,0.156 10 false *b 0.323,1.531 0.667,1.708 0.344,0.177 10 true SST
*a Turn
*b Hold


Using SST, remove the steering wheel assembly.

SST
09950-50013  (09951-05010, 09952-05010, 09953-05020, 09954-05031)

NOTICE:

Apply a small amount of grease to the threads and tip of SST (09953-05020) before use.



Hide 45186 4.REMOVE LOWER NO. 2 STEERING WHEEL COVER

Hide 84632 5.REMOVE CRUISE CONTROL MAIN SWITCH

Hide 84250A 6.REMOVE STEERING PAD SWITCH ASSEMBLY