The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during the headlight dimmer switch assembly removal/installation are shown below.
When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
84307
1.REMOVE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY
84650
2.REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY
84140
3.REMOVE HEADLIGHT DIMMER SWITCH ASSEMBLY
|
Remove in this Direction |
Disconnect the connector.
Disengage the claws to remove the headlight dimmer switch assembly as shown in the illustration.