Home › Engine / Hybrid System › CRUISE CONTROL › FRONT CAMERA SYSTEM › from 2020.08
RM32K0E _51 Engine / Hybrid System _061336 CRUISE CONTROL _0440928 FRONT CAMERA SYSTEM D

CRUISE CONTROL  FRONT CAMERA SYSTEM  VEHICLE CONTROL HISTORY  


NOTICE:

Vehicle control history may be recorded due to the replacement or repair of related parts.


CHECK VEHICLE CONTROL HISTORY (FRONT CAMERA SYSTEM)


a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Chassis / Front Recognition Camera / Utility / Vehicle Control History (RoB)

Chassis > Front Recognition Camera > Utility
Tester Display
Vehicle Control History (RoB)
50005 430 55

e.

Read the Vehicle Control History (RoB) according to the display on the GTS.

Vehicle Control History (RoB)
Multi-information Display Code Tester Display Description Diagnostic Note
Pre-Collision System Malfunction Visit Your Dealer X2000 Yaw Rate Sensor Malfunction The forward recognition camera received a yaw rate sensor (airbag sensor assembly) malfunction signal from the skid control ECU (brake booster with master cylinder assembly). Perform troubleshooting for the electronically controlled brake system.
Click here(Click here)
Pre-Collision System Malfunction Visit Your Dealer X2004 Speed Sensor Malfunction The forward recognition camera received a vehicle speed sensor malfunction signal from the skid control ECU (brake booster with master cylinder assembly). Perform troubleshooting for the electronically controlled brake system.
Click here(Click here)
Pre-Collision System Malfunction Visit Your Dealer X2014 Front Recognition Camera Optical Axis Not Adjusted Forward recognition camera optical axis adjustment has not been performed.
HINT:

Forward recognition camera axis alignment can be performed by using either One Time Recognition, Sequential Recognition or Driving Adjustment.

One Time Recognition: Click here(Click here)

Sequential Recognition: Click here(Click here)

Driving Adjustment: Click here(Click here)


Front Camera Low Visibility Unavailable See Owner's Manual X2015 Front Recognition Camera Dirt System operation was temporarily suspended due to the forward recognition camera not being able to detect objects. Check if any of the following conditions are met:
·

Non-Toyota genuine front wiper blades are installed

·

The front wiper rubbers are worn

·

A sticker, accessory or other object is obstructing the forward recognition camera

·

There is snow, frost, dirt, dust or oil on the windshield glass, or the windshield glass is fogged up

·

The windshield glass is chipped or cracked

·

Non-Toyota genuine windshield glass is installed

·

Confirm the vehicle was not driven in bad weather (If temporary conditions that affected the camera such as darkness, backlighting, fog, etc. have improved, the displayed warning is cleared).


Factor:

The area in front of the forward recognition camera is dirty or obstructed by foreign matter.


Front Camera Out of Temperature Range Unavailable Wait until Normal Temperature X2016 Front Recognition Camera Outside Guaranteed Operating Temperature System operation was temporarily suspended due to the forward recognition camera being excessively hot or cold.
1.

Using the GTS, check the following items for the front recognition camera in the Data List.

(Click here)

-

Front Recognition Camera Low Temperature

-

Front Recognition Camera High Temperature 1


2.

If the display value for the Data List check items are displayed as "High Temperature" or "Low Temperature", perform the procedures listed in the diagnostic notes.

(Click here)


Cause:

The forward recognition camera is in one of the following conditions

-

When the ambient temperature is approximately -30°C (-22°F) or less, such as when the vehicle is left alone in an extremely cold environment

-

When the ambient temperature is approximately 80°C (176°F) or higher, such as when the vehicle is left alone in an extremely an extremely hot environment



Front Camera Unavailable See Owner's Manual X2017 Front Recognition Camera Outside Guaranteed Operating Voltage System operation was temporarily suspended due to forward recognition camera power source voltage being excessively high or low. Check the power source voltage of the forward recognition camera (terminal IGB). Refer to (Click here)for the terminal inspection and standard voltage.
If the power source voltage is within the specified range and "Front Camera Unavailable See Owner's Manual" is displayed in the multi-information display, the forward recognition camera may be malfunctioning.
Cause:

The forward recognition camera is in one of the following conditions

-

When the input voltage is approximately 9 V or less, immediately after starting the hybrid system

-

When the input voltage is approximately 16 V or higher, immediately after starting the hybrid system



- X204A Acceleration Sensor Malfunction The forward recognition camera received an acceleration sensor malfunction signal from the skid control ECU (brake booster with master cylinder assembly). Perform troubleshooting for the electronically controlled brake system.
Click here(Click here)



CLEAR VEHICLE CONTROL HISTORY (FRONT CAMERA SYSTEM)


NOTICE:

By performing this procedure, all stored Vehicle Control History will be cleared.


a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Chassis / Front Recognition Camera / Utility / Vehicle Control History (RoB)

Chassis > Front Recognition Camera > Utility
Tester Display
Vehicle Control History (RoB)
50005 430 55

e.

Clear the Vehicle Control History (RoB) according to the display on the GTS.