Home › Vehicle Interior › PRE-COLLISION › PRE-COLLISION SYSTEM › from 2020.08
RM32K0E _58 Vehicle Interior _061839 PRE-COLLISION _0303861 PRE-COLLISION SYSTEM U

PRE-COLLISION  PRE-COLLISION SYSTEM  TERMINALS OF ECU  


CHECK MILLIMETER WAVE RADAR SENSOR ASSEMBLY


NOTICE:
·

Turning the power switch on (IG) with connectors disconnected may cause DTCs to be stored. Make sure to clear the DTCs after inspection has been performed.

·

Do not apply excessive force to the millimeter wave radar sensor assembly connector.



A402620E34
3.365,0.063 3.792,0.302 0.427,0.24 3.479,0.083 3.938,0.281 0.458,0.198 10 false A2

a.

Measure the voltage and resistance according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
A2-8 (IGB) - A2-1 (SGND) B - W-B Power source Power switch on (IG) 11 to 14 V
Power switch off Below 1 V
A2-1 (SGND) - Body ground W-B - Body ground Ground Always Below 1 Ω