The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during engine water pump assembly removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/Replaced
| Replaced Part or Performed Procedure
|
Necessary Procedure
|
Effect/Inoperative Function when Necessary Procedure not Performed
|
Link
|
| Disconnect cable from negative auxiliary battery terminal
|
Memorize steering angle neutral point
|
Panoramic view monitor system
|
( )
|
| Replacement of inverter with converter assembly
|
Resolver learning
|
·
Slight vibration at a vehicle speed of 5 km/h (3 mph) or less
·
Shock or vibration during acceleration
|
for 2ZR-FXE (for Nickel Metal Hydride Battery):( )
for 2ZR-FXE (for Lithium-ion Battery):( )
|
|
Perform Vehicle Identification Number (VIN) registration
|
MIL comes on
|
( )
|
for 2ZR-FXE
·
Replacement of throttle body assembly
·
Replacement of engine assembly
·
Gas leak from exhaust system is repaired
|
Inspection After Repair
|
·
Engine start function, etc.
|
( )
|
Suspension, tires, etc.
(The vehicle height changes because of suspension or tire replacement)
|
Initialize headlight ECU sub-assembly LH
|
Automatic headlight beam level control system
|
( )
|
| Front wheel alignment adjustment
|
1.
Clear zero point calibration data.
2.
Perform yaw rate and acceleration sensor zero point calibration.
|
·
ABS warning light illuminates
·
Brake warning light/yellow (minor malfunction) illuminates
·
Slip indicator light illuminates
·
VSC disabled or malfunctions
|
for Initialization:( )
for Calibration:( )
|
| Replacement of hybrid vehicle transaxle assembly
|
|
·
Slight vibration at a vehicle speed of 5 km/h (3 mph) or less
·
Shock or vibration during acceleration
|
for 2ZR-FXE (for Nickel Metal Hydride Battery):( )
for 2ZR-FXE (for Lithium-ion Battery):( )
|
- HINT:
-
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
·
Learning completes when vehicle is driven
| Effect/Inoperative Function When Necessary Procedures are not Performed
|
Necessary Procedures
|
Link
|
|
|
| Lane tracing assist system
|
Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more.
|
( )
|
| Pre-collision system
|
| Simple intelligent parking assist system*1
|
| Parking support brake system*1
|
| Toyota parking assist-sensor system*1
|
·
Learning completes when vehicle is operated normally
| Effect/Inoperative Function When Necessary Procedures are not Performed
|
Necessary Procedures
|
Link
|
Power door lock control system
|
Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch.
|
( )
|
| Air conditioning system
|
After the ignition switch is turned to ON, the servo motor standard position is recognized.
|
-
|