Home › Power Source / Network › 2ZR-FXE (BATTERY / CHARGING) › BATTERY CURRENT SENSOR › from 2020.08
RM32K0E _57 Power Source / Network _060220 2ZR-FXE BATTERY / CHARGING _0300002 BATTERY CURRENT SENSOR A

2ZR-FXE BATTERY / CHARGING  BATTERY CURRENT SENSOR  INSTALLATION  


PROCEDURE

Hide 28850C 1.INSTALL BATTERY STATE SENSOR ASSEMBLY

a.

Engage the 2 claws and install the battery state sensor assembly to the battery current sensor holder.


b.

Install the battery state sensor assembly to the auxiliary battery and tighten the nut.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


c.

Connect the engine wire to the battery state sensor assembly with the nut.

Torque:
7.6 N*m (77 kgf*cm, 67 in.*lbf)


d.

Connect the battery state sensor assembly connector.


e.

Engage the 2 claws to connect the wire harness to the battery current sensor holder.


Hide 2. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART