Home › General › MAINTENANCE › M20A-FXS AUXILIARY BATTERY › from 2020.08
RM32K0E _V1 General _059911 MAINTENANCE _0404803 M20A-FXS AUXILIARY BATTERY A

MAINTENANCE  M20A-FXS AUXILIARY BATTERY  REMOVAL  


CAUTION / NOTICE / HINT

HINT:

When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link

*1: When performing learning using the GTS

Click here(Click here)

Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system
Simple intelligent parking assist system*1
Parking support brake system*1
Toyota parking assist-sensor system*1

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



PROCEDURE

Hide 1. PRECAUTION

NOTICE:
·

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When replacing the auxiliary battery, use a new auxiliary battery of the same dimensions with a capacity of 51 Ah or more at a 20-hour rate.



Hide 58410B 2.REMOVE DECK BOARD ASSEMBLY

Hide 58440 3.REMOVE BATTERY SERVICE HOLE COVER ASSEMBLY (w/o Spare Tire)

a.
A451650C01
0,0 0,0 false
V113147

Remove in this Direction


Remove the battery service hole cover assembly as shown in the illustration.


Hide 4.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

a.
A451417

Loosen the nut and disconnect the cable from the negative (-) auxiliary battery terminal.


Hide 5.REMOVE AUXILIARY BATTERY

a.
A429314C01
0,0 0,0 false
V113147

Open


Disengage the claw and open the battery terminal cap shown in the illustration.


b.
A429316

Loosen the nut and disconnect the cable from the positive (+) auxiliary battery terminal.


c.
A454082

Disconnect the auxiliary battery hose.


d.
A454083

Remove the bolt, nut and battery clamp sub-assembly.


e.
A451418

Remove the auxiliary battery from the vehicle shown in the illustration.