Home › Power Source / Network › M20A-FXS (BATTERY / CHARGING) › BATTERY CURRENT SENSOR › from 2020.08
RM32K0E _57 Power Source / Network _084047 M20A-FXS BATTERY / CHARGING _0404793 BATTERY CURRENT SENSOR A

M20A-FXS BATTERY / CHARGING  BATTERY CURRENT SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:
·

After the power switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the power switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal (for Audio and Visual System).

·

After the power switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the power switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal (for Navigation System (for Radio and Display Type)).



HINT:

When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link

*1: When performing learning using the GTS

Click here(Click here)

Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system
Simple intelligent parking assist system*1
Parking support brake system*1
Toyota parking assist-sensor system*1

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



PROCEDURE

Hide 1. PRECAUTION

NOTICE:
·

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When replacing the auxiliary battery, use a new auxiliary battery of the same dimensions with a capacity of 51 Ah or more at a 20-hour rate.



Hide 58410B 2.REMOVE DECK BOARD ASSEMBLY

Hide 28850C 3.REMOVE BATTERY STATE SENSOR ASSEMBLY

a.
A451421

Remove the nut and disconnect the No. 2 frame wire from the battery state sensor assembly.


b.
A451420

Loosen the nut and remove the battery state sensor assembly from the auxiliary battery.


c.
A438832

Disconnect the battery state sensor assembly connector.


d.
A438833

Disengage the 2 claws to remove the battery state sensor assembly from the battery current sensor holder.