Home › Power Source / Network › M20A-FXS (BATTERY / CHARGING) › BATTERY CURRENT SENSOR › from 2020.08
RM32K0E _57 Power Source / Network _084047 M20A-FXS BATTERY / CHARGING _0404793 BATTERY CURRENT SENSOR A

M20A-FXS BATTERY / CHARGING  BATTERY CURRENT SENSOR  INSTALLATION  


PROCEDURE

Hide 28850C 1.INSTALL BATTERY STATE SENSOR ASSEMBLY

a.

Engage the 2 claws to install the battery state sensor assembly to the battery current sensor holder.


b.

Connect the battery state sensor assembly connector.


c.

Install the battery state sensor assembly to the auxiliary battery and tighten the nut.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


d.

Connect the No. 2 frame wire to the battery state sensor assembly with the nut.

Torque:
7.6 N*m (77 kgf*cm, 67 in.*lbf)


Hide 58410B 2.INSTALL DECK BOARD ASSEMBLY

Hide 3. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART