The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the antenna divider removal/installation are shown below.
After the power switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the power switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is driven
Use the same procedure for RHD and LHD vehicles.
The following procedure is for LHD vehicles.
55401E
1.REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
55950G
2.REMOVE DEFROSTER NOZZLE ASSEMBLY
86681C
3.REMOVE ANTENNA DIVIDER
Remove the screw.
Disengage the guide to remove the antenna divider.