Home › Vehicle Interior › SEAT › FRONT SEATBACK HEATER (for Manual Seat) › from 2020.08
RM32K0E _58 Vehicle Interior _061825 SEAT _0409033 FRONT SEATBACK HEATER(for Manual Seat) A

SEAT  FRONT SEATBACK HEATER(for Manual Seat)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the front seatback heater assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Panoramic view monitor system (Click here)

CAUTION:
·
B458500

Be sure to read Precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION

·
B407261

Wear protective gloves. Sharp areas on the parts may injure your hands.



HINT:
·

When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

-

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link

*1: When performing learning using the GTS

Click here(Click here)

Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system
Simple intelligent parking assist system*1
Parking support brake system*1

-

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -


·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.

·

Use the same procedure for the driver side and front passenger side.

·

The procedure listed below is for the driver side.



PROCEDURE

Hide 71074S 2.DISCONNECT SEPARATE TYPE FRONT SEATBACK COVER

Hide 72495 3.REMOVE VERTICAL ADJUSTING HANDLE (w/ Vertical Adjuster)

Hide 72538 4.REMOVE RECLINING HINGE OUTER COVER

Hide 72526A 5.REMOVE RECLINING ADJUSTER RELEASE HANDLE

Hide 71849F 6.REMOVE SEAT ADJUSTER COVER CAP (w/ Vertical Adjuster)

Hide 71812D 7.REMOVE FRONT SEAT CUSHION SHIELD (for Driver Side)

Hide 71862 8.REMOVE FRONT SEAT INNER CUSHION SHIELD (for Driver Side)

Hide 71811D 9.REMOVE FRONT SEAT CUSHION SHIELD (for Front Passenger Side)

Hide 71861 10.REMOVE FRONT SEAT INNER CUSHION SHIELD (for Front Passenger Side)

Hide 11.REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY

Hide 71931 12.REMOVE FRONT SEAT HEADREST SUPPORT

Hide 13.REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD

Hide 71074S 14.REMOVE SEPARATE TYPE FRONT SEATBACK COVER

Hide 87510N 15.REMOVE FRONT SEATBACK HEATER ASSEMBLY

a.
B453973

Remove the 16 tag pins and front seatback heater assembly from the separate type front seatback cover.