Home › Vehicle Interior › SEAT › SEAT HEATER CONTROL (for Power Seat) › from 2020.08
RM32K0E _58 Vehicle Interior _061825 SEAT _0409040 SEAT HEATER CONTROL(for Power Seat) A

SEAT  SEAT HEATER CONTROL(for Power Seat)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the seat heater control sub-assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Panoramic view monitor system (Click here)

CAUTION:
·
B458500

Be sure to read Precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION

·
B407261

Wear protective gloves. Sharp areas on the parts may injure your hands.



NOTICE:

If the front seat airbag assembly has been deployed, replace the front seat airbag assembly, front seatback frame sub-assembly, separate type front seatback pad and separate type front seatback cover with the necessary parts in accordance with the extent of the collision damage.


HINT:
·

When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

-

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link

*1: When performing learning using the GTS

Click here(Click here)

Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system
Simple intelligent parking assist system*1
Parking support brake system*1

-

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -


·

Power seat is available only on the driver side.

·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1.REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD

Hide 73240 2.REMOVE FRONT SEAT INNER BELT ASSEMBLY

Hide 82192B 3.REMOVE NO. 2 FRONT SEAT WIRE (w/ Seat Position Airbag Sensor)

Hide 82192 4.DISCONNECT FRONT SEAT WIRE

a.
B439736

Disengage the claw to disconnect the front seat wire.


Hide 71052A 6.REMOVE FRONT SEAT CUSHION SPRING SUB-ASSEMBLY

Hide 7181B 7.REMOVE FRONT SEAT CUSHION WIRE HARNESS HOLDER

Hide 87501B 8.REMOVE SEAT HEATER CONTROL SUB-ASSEMBLY

a.
B558478

Disengage the claw to remove the seat heater control sub-assembly.